Toyohashi ACROSS Operation Monitoring
Updated hourly (Borehole data), daily (Source log).
Toyohashi ACROSS at Mikawa Observatory
FY2019
Operation started at 2012.04.03 16:00
NU.MIKB1 | NU.MIKB2 | Data | Log |
Source No.1 (Z) | Source No.1 (H1) | Source No.1 (H2) | Source No.2 (Z) | Source No.2 (H1) | Source No.2 (H2) | Data | Log No.1 | Log No.2 | Log No.1 | Log No.2 |
|
|
|
|
|
|
|
|
|
|
|
Sensor
NU.MIKB1 and NU.MIKB2 : located approximately 10 meters below each source.
Amplitude
- Transmission bandwidth: 5.0150-15.0150 Hz for Soruce No.1
- Transmission bandwidth: 5.0075-15.0075 Hz for Soruce No.2
- Amplitude of vertical accelaration within the specified frequency band is evaluated.
- Analysis bandwidth: 08-15 Hz for signal (fundamental mode)
- Analysis bandwidth: 16-30 Hz for harmonics (2nd higher mode)
- Note: Source No.1 is just for reference. The signal of Source No.1 is contaminated by the 2nd higher mode of Source No.2 at 10-15 Hz.
Data
- Data loss (s) = 3600 (s) - Number of 1 s block in a data file obtained by 'wck'
- Size: Size of data file (byte)
Log
- Status: OK:OK, NL:No log file, S:Stop (No operation), R:Reverse (Opposite) judged by dF.
- dF: Square sum of the difference of Frequency series between actual (monitored) frequency in the Log file and the designed frequency series.
- Log write failure: Number of missing entries (seconds) in a Log file in every 1 hour
- Temperature: Temperature of oil outflow from the source.
- Df: Difference of monitor frequency from carrier ferquency at 00mim 00sec